Along with matching copper to interference-free fiber at Gigabit speeds, the converter doubles as power sourcing equipment PSE for Power over Ethernet PoE devices plugged in on the copper side.Using existing UTP cabling for both data communications and 48-VDC power simplifies a network application in terms of provisioning power and maintaining equipment. It's particularly ideal for locating equipment where electrical access is inconvenient or just too expensive to locate. Install PoE-compatible security cameras and wireless access points in areas without any nearby power outlets while reducing your overall power consumption, too.
Features- A low-, economical solution for powering poe devices over the same catx link used for data communications
- Powered device pd signature sending detects when a poe device is connected
- Protects against damage caused by overcurrent events and offers undercurrent detection
- Link fault passthrough monitors both copper and fiber receive ports for loss of signal
- Far-end fault detection prevents the loss of valuable data from it being sent over an invalid link
- Supports 802.3x flow control on full-duplex ports and backpressure on 10base-t/100base-tx half-duplex ports
- Jumbo frame support 2 kb, normal mode 9 kb, cut-through mode
- Copper port autonegotiates for network speed and features auto mdi-x for easy cabling
- Leds indicate when it is feeding poe power as well as when power is interrupted
- Rohs compliant
Specifications
